Sunday, October 20, 2024

25/28mm Things From the Basement - Livestock Buildings

Great set from Thing From the Basement! My trials and tribulations are detailed below,

I screwed up the priming twice! For the fencing, I mixed up some dark brown paint and Gesso and brush-primed them before spraying with a light brown primer.  It looked good at first but I found it repelled portions of the washes I put on. It was irregular enough that I leaned into it and I tried to drybush grays and tans over to age it up a bit. Some lengths are better than others - the gate among the worst.
 
For the buildings themselves, I managed to put a thick gritty dust over everything with the priming. I brushed the worst of it off to middling effect. This is most seen on the outhouse, but also on the pig sty to a lesser extent. Hen house came out fine.

I'm happy with the basing on everything but I used UV activated resin in the horse trough and it seemed smooth and fine until I hit it with the light. At that point a bunch of bubbles appeared on the right side. By then the top was rock hard! I may very well have made it too deep and should have set it in two layers for more control. I can live with it I guess; on the table it will get little notice.

I'm also happy with the state of the pig sty - at least at pig pens I have seen they are totally littered with straw which I successfully modeled here. I own 25mm pigs; none are painted.

That grit is gritty!


Here's some 25mm Wars of Ozz figures so you can get a sense of the size. I will likely use these livestock buildings for Napoleonics, both Russia and Spain, and probably New England too.

All and all, there is a learning curve in prepping laser cut stuff. The pig sty base did warp a bit and I flipped it over and white glued the bottom to put a counter pull on it. On a cloth mat it sits level but there it's still not flat. The glue for the static grass and tufts on the fencing, I think, will not affect them but they are not 100% cured yet. For now, I'm skittish about trying to build bigger laser cut buildings.

In any event, thanks for looking. Questions, comments and followers are welcome and encouraged! I'm doing more and more on Facebook so follow my page there too! https://www.facebook.com/One-of-My-Men-Became-Restless-100659928063858

No comments:

Post a Comment